Руководство По Установке для Cisco Cisco 5760 Wireless LAN Controller

When prompted to verify that the configuration is correct, enter one of the following:

0—Go to the IOS command prompt without saving this config.

1—Return back to the setup without saving this config.

2—Save this configuration to nvram and exit.

Follow these steps to log into the controller:

Enter a valid username and password to log into the controller CLI.

The administrative username and password you created in the Startup Wizard are case 
sensitive.

The CLI displays the root level system prompt:

#(system prompt)> 

The system prompt can be any alphanumeric string up to 31 characters. You can change it by entering 
the config prompt command.

The CLI automatically logs you out without saving any changes after 5 minutes of inactivity. 
You can set the automatic logout from 0 (never log out) to 160 minutes using the config 
serial timeout command.

Cisco Aironet lightweight access points do not connect to the Cisco 5700 Series Wireless 
Controller if the date and time are not set properly. Set the current date and time on the 
controller before allowing the access points to connect to it.

Follow these steps to verify that your interface configurations have been set properly and the controller’s 
ports are operational.

Enter show interface summary. The controller’s current interface configurations appear:

Interface Name                    Port  Vlan Id   IP Address      Type     Ap Mgr

Guest

--------------------------------  ----  --------  --------------  -------  ------- -----

management                        LAG   untagged  10.91.104.93    Static   Yes

No

service-port                      N/A   N/A       10.10.0.9       Static   No

No

virtual                           N/A   N/A       1.1.1.1         Static   No

No