Руководство По Установке для Cisco Cisco TelePresence MX700
D14639.06 Video Systems Getting Started Guide (TC5.1) | 2012 FEBRUARY | © 2011-2012 Cisco Systems, Inc. All rights reserved.
www.cisco.com
17
GettinG started Guide
remote control and on-screen menu
Configuration using the remote control and on-screen menu
Waking up the system
If there is no menu on screen, press
Home
( )
on the
remote control to show the menu.
If the system does not show a menu on screen:
• Make sure the monitor is connected and has been
switched on.
• Make sure the remote control has the batteries installed.
• Make sure the system is switched on.
• Make sure the system is switched on.
If the system has just been switched on, wait a few minutes
to allow the system to start up.
If there is still no menu on screen, make sure the monitor
cable is connected to the basic video output connector. If in
doubt, see the Installation guide for your product.
Remote control and
on-screen menu
Back to task overview
User interfaces
Introduction
Configuration
Table of contents
Appendices
Configuration