Руководство По Установке для Cisco Cisco TelePresence MX700

D14639.06 Video Systems Getting Started Guide (TC5.1) | 2012 FEBRUARY | © 2011-2012 Cisco Systems, Inc. All rights reserved. 

www.cisco.com

15

Configuring H.323 and SIP

(when not set by a provisioning system)

To get online and ready to place and receive calls, your 

system must be set up properly. Your system uses either 

the H.323 protocol or the SIP protocol for video calls.

NoTE:

 Contact your system administrator, or service 

provider, for information about the network settings.

For networks administered through Cisco TMS (Cisco 

TelePresence Management Suite) your Cisco TMS 

administrator will help you to get online.

H.323

If in doubt about any of the parameters below, contact your 

system administrator or your service provider.

1. Tap 

 

2. Enter the 

and 

in their respective 

input fields.

3. If you want to enter the address of the H.323 gatekeeper 

manually, tap 

 in the 

section, and enter the 

 in the input 

field. Otherwise tap 

.

4. If the H.323 gatekeeper requires authentication and 

you want your system to authenticate itself to the 

gatekeeper, tap 

 in the 

 section 

and enter the 

and 

 in their 

respective input fields. Otherwise, tap 

.

5. Tap 

 to save the changes, or 

 to leave without 

saving.

6. Tap 

 twice to review the System Information page 

and verify the H323 settings.
If you successfully registered to the Gatekeeper the 

is shown as 

in the H323 section.

7. Tap 

 to return to the home menu.

SIP

If in doubt about any of the parameters below, contact your 

system administrator or your service provider.

1. Tap 

 

2. Enter the SIP URI in the 

 input field.

3. Tap the preferred transport protocol in the 

section. If you select 

, the system first 

tries to connect using TLS, then TCP, and finally UDP.

4. Select a 

. Step through the list of available 

proxy types by tapping the - or + signs. The default type 

is 

.

5. If you want to enter the SIP proxy address manually, tap 

 in the

 section and enter the

 in the input field. If you want the system 

to obtain the SIP proxy address automatically (DHCP), 

tap 

.

6. If the SIP proxy server requires authentication you must 

enter the 

and 

 in their respective 

input fields to authenticate your system.

7. Tap 

 to save the changes, or 

 to leave without 

saving.

8. Tap 

 twice to review the System Information page 

and verify the SIP settings.
If you successfully registered to a SIP server the 

 

is shown as 

in the SIP section.

9. Tap 

 to return to the home menu.

Back to task overview

User interfaces

Introduction

Configuration

Table of contents

Appendices

Configuration