Руководство По Установке для Cisco Cisco TelePresence MX700

D14639.06 Video Systems Getting Started Guide (TC5.1) | 2012 FEBRUARY | © 2011-2012 Cisco Systems, Inc. All rights reserved. 

www.cisco.com

29

Setting the menu password using the command line interface

When starting up the system for the first time the 

Administrator Settings menu password is not set. 

NoTE:

We strongly recommend that you define a password 

to protect the Administrator Settings menu, since these 

settings affect the behavior of the video conference system.

The Administrator Settings menu password cannot be set 

using the Touch controller. If your system does not have a 

remote control, you have to set the menu password from 

the command line interface.

Signing in to the command line interface

1. To find the IP address of the system, tap 

 on the Touch controller.

The IPv4 Address and/or IPv6 Address is listed in the 

NETWORK

section.

2. Open a command line interface (SSH or Telnet) using 

the system's IP address.

3. Enter your codec/system user name and password when 

prompted.
The default user name is 

admin

 with no password set.

Setting the menu password

1. Connect to the system through the network or the 

serial data port, using a command line interface (SSH or 

Telnet).

2. Type the following command:

xCommand SystemUnit MenuPassword Set 

Password: <password>

The password format is a string with 0–255 characters.

Back to task overview

User interfaces

Introduction

Configuration

Table of contents

Appendices

Configuration