Руководство По Установке для Cisco Cisco TelePresence MX700

D14639.06 Video Systems Getting Started Guide (TC5.1) | 2012 FEBRUARY | © 2011-2012 Cisco Systems, Inc. All rights reserved. 

www.cisco.com

27

Configuring H.323 and SIP

(when not set by a provisioning system)

To get online and ready to place and receive calls, your 

system must be set up properly. Your system uses either 

the H.323 protocol or the SIP protocol for video calls.

NoTE:

 Contact your system administrator, or service 

provider, for information about the network settings.

For networks administered through Cisco TMS (Cisco 

TelePresence Management Suite) your Cisco TMS 

administrator will help you to get online.

H.323

If in doubt for any of the parameters below, contact your 

system administrator or your service provider.

1. Go to the 

tab and select

.

Open the 

 settings from the left column.

2. Under the 

 heading, enter the 

 and 

 

number in their respective input fields.

3. Go to the 

 heading. 

If you want the system to obtain the H.323 gatekeeper 

address automatically, select 

 in the 

drop 

down list; if you want to enter the address manually, 

select

If set to 

 enter the gatekeeper

 in the 

corresponding input field. Click 

to save the change.

4. If the H.323 gatekeeper requires authentication and 

you want your system to authenticate itself to the 

gatekeeper, go to the 

 heading and 

select 

 in the 

 drop down list. Then enter the 

and 

 in the corresponding input 

fields. Click 

to save the change.

Otherwise, select 

in the 

 drop down list.

5. Go to the 

tab and select

to verify the H323 settings.
If you successfully registered to a Gatekeeper the 

 

is shown as 

in the H323 section.

Please check the Administrator guide for your product if you 

want to change the other H.323 settings.

SIP

If in doubt for any of the parameters below, contact your 

system administrator or your service provider.

1. Go to the 

tab and select

.

Open the 

 page from the sidebar on the left.

2. Enter the SIP URI in the 

 input field, and optionally a 

display name in the 

 input field. Click 

to 

save the change.

3. Select the preferred transport protocol from the 

 drop down list. If you select 

, the 

system first tries to connect using TLS, then TCP, and 

finally UDP.

4. Select a proxy type in the 

 drop down list. The 

default type is 

.

5. Go to the 

heading.

If you want the system to obtain the SIP proxy address 

automatically, select 

 in the

 drop down 

list; if you want to enter the address manually, select 

.

If you select 

 enter the proxy

 in the 

corresponding input field. Click 

to save the change.

6. If the SIP proxy requires authentication you must enter a 

login name and password to authenticate your system. 

Go to the 

 heading and enter the 

and 

 in the corresponding input 

fields. Click 

to save the change.

7. Go to the 

tab and select

to verify the SIP settings.
If you successfully registered to a SIP server the 

 

is shown as 

in the SIP section.

Please check the Administrator guide

for your product if you 

want to change the other SIP settings.

Back to task overview

User interfaces

Introduction

Configuration

Table of contents

Appendices

Configuration