Листовка для Cisco Cisco TelePresence MX700
Cisco TelePresence Endpoints and Cisco Unified Communications Manager
Quick Reference Guide
D14996.08 Administering TC7.0 Endpoints on CUCM 9.1.2, AUGUST 2014.
www.cisco.com — Copyright © 2014 Cisco Systems, Inc. All rights reserved.
36
Endpoint configuration in three steps
Setting the system password
We strongly recommend setting a password for the users to
We strongly recommend setting a password for the users to
restrict access to system configuration. If no password is set
there will be a notification on screen.
Go to:
Go to:
.
Setting the call details
The auto answer settings provisioned in Cisco Unified CM are
The auto answer settings provisioned in Cisco Unified CM are
ignored by the endpoint and must be set on the endpoint.
The call rate will not be set by CUCM. Set the call rate to match
The call rate will not be set by CUCM. Set the call rate to match
the camera capabilities to achieve the desired call quality.
Go to:
Go to:
Provisioning the endpoint to CUCM
Provisioning allows the video conferencing network
Provisioning allows the video conferencing network
administrators to manage many video systems simultaneously.
Go to:
Go to:
.
About endpoint configuration
This section gives an overview of the steps required for
registering a TelePresence endpoint to Cisco Unified CM.
You can use the
You can use the
to configure the
endpoint. Your TelePresence system is shipped with either a
Touch panel or a remote control.
NOTE:
We recommend doing the CUCM configuration
before the endpoint provisioning, as access through HTTP
(web interface) and SSH (command line) to the endpoint will
be disabled by default.
Endpoint diagnostic tools
If having trouble using the TelePresence endpoint diagnostic
tools when the endpoint is provisioned to CUCM, check that
the SIP listen port is set to Off (default). Log in to the web
interface of the endpoint and go to: Configuration > System
Configuration > SIP > ListenPort.
Finding the IP address
If using the web interface or the command line interface you
will need the IP address of the endpoint.
Use the Touch controller or remote control to find the address.
Use the Touch controller or remote control to find the address.
• Using the Touch controller: Tap (Settings) > System
Information and see the General section.
• Using the remote control: Navigate to Home > Settings >
System Information and see the Network section.
Contents
Introduction
CUCM configuration
Endpoint configuration
About passwords
Appendices
Endpoint configuration