Листовка для Cisco Cisco TelePresence MX700
Setting the call details
If in doubt for any of the parameters below,
contact your system administrator or your
service provider.
The auto answer settings provisioned in Cisco
Unified CM are ignored by the endpoint and
must be set on the endpoint.
The call rate will not be set by CUCM. Set the
call rate to match the camera capabilities to
achieve the desired call quality.
When used with Cisco TelePresence Multipoint
Switch (CTMS), the recommended value is
2500 kbps, or higher.
Cisco TelePresence Endpoints and Cisco Unified Communications Manager
Quick Reference Guide
D14996.08 Administering TC7.0 Endpoints on CUCM 9.1.2, AUGUST 2014.
www.cisco.com — Copyright © 2014 Cisco Systems, Inc. All rights reserved.
38
Using the Touch panel
Tap (Settings) > Administrator > Call Details.
1. Configure the auto answering
Set Auto Answer to the desired value.
If appropriate set the Auto Answer Delay.
If appropriate set the Auto Answer Delay.
2. Configure the default call settings
Set the Default Call Rate to the
appropriate value. Tap the plus (+) or
minus (-) buttons to increase or decrease
the value.
In Cisco UCM mode the Default Call
In Cisco UCM mode the Default Call
Protocol is automatically set to SIP, and
H.323 is not supported.
Using the remote control
Navigate to Home > Settings > Administrator
Settings > Advanced Configuration >
Conference 1
1. Configure the auto answering
Navigate to Home > Settings >
Administrator Settings > Advanced
Configuration > Conference 1 >
AutoAnswer and set appropriate values for
auto answer Delay, Mode and Mute.
Click Ok to save the change.
Click Ok to save the change.
2. Configure the default call settings
Use the remote control and go to the
DefaultCall section and set the Rate to
the appropriate value.
In Cisco UCM mode the Default Call
In Cisco UCM mode the Default Call
Protocol is automatically set to SIP, and
H.323 is not supported.
Click Ok to save the change.
Click Ok to save the change.
Using the command line interface
Open a command line interface (e.g. PuTTY)
and log in to the endpoint (codec):
1. Configure the auto answering
xConfiguration Conference 1
AutoAnswer Mode: <On/Off>
[must be set locally on the endpoint]
xConfiguration Conference 1
xConfiguration Conference 1
AutoAnswer Mute: <On/Off>
[must be set locally on the endpoint]
xConfiguration Conference 1
xConfiguration Conference 1
AutoAnswer Delay: <0..50>
[must be set locally on the endpoint]
2. Configure the default call settings
xConfiguration Conference 1
DefaultCall Rate: <64..6000> [when
used with CTMS; 2500 kbps or higher]
xConfiguration Conference 1
xConfiguration Conference 1
DefaultCall Protocol: SIP [must be
SIP for CUCM mode]
Using the web interface
Navigate to Configuration > Advanced
Configuration > Conference.
3. Configure the auto answering
Go to the Auto Answer section and set
appropriate values for Delay, Mode and
Mute.
Click Save after each change.
Click Save after each change.
4. Configure the default call settings
Go to the DefaultCall section and set the
Rate to the appropriate value.
In Cisco UCM mode the Default Call
In Cisco UCM mode the Default Call
Protocol is automatically set to SIP, and
H.323 is not supported.
Click Save.
Click Save.
Contents
Introduction
CUCM configuration
Endpoint configuration
About passwords
Appendices
Endpoint configuration