Руководство По Устранению Ошибки для Cisco Cisco Packet Data Gateway (PDG)
Always-on
Configuring Always-on ▀
Cisco ASR 5000 Series Enhanced Feature Configuration Guide ▄
OL-22982-01
Configuring Always-on
To configure Always-on for a subscriber:
Step 1
Configure Always-on as described in the
Step 2
Verify your configuration as described in the
Step 3
Save your configuration as described in the Saving Your Configuration chapter.
Important:
Commands used in the configuration examples in this section provide base functionality to the extent
that the most common or likely commands and/or keyword options are presented. In many cases, other optional
commands and/or keyword options are available. Refer to the Command Line Interface Reference for complete
information regarding all commands.
commands and/or keyword options are available. Refer to the Command Line Interface Reference for complete
information regarding all commands.
Configuring Always-on
Use the following example to configure Always-on:
Notes:
must be the name of the destination context where the subscriber that you want to enable
always-on is configured.
Option: To configure the echo-retransmit-timeout setting to wait before sending a keepalive message to an
always-on subscriber, in the Context Configuration Mode, enter the following command:
Option: To configure the echo-max-retransmissions setting to retransmit a Keepalive message to a subscriber, in
the Context Configuration Mode use the following command:
The optional echo-retransmit-timeout and echo-max-retransmissions settings apply to all subscriber sessions
within the current context that have always-on enabled.