Руководство По Устранению Ошибки для Cisco Cisco Packet Data Gateway (PDG)
IP Security
Transform Set Configuration ▀
Cisco ASR 5000 Series Enhanced Feature Configuration Guide ▄
OL-22983-01
Transform Set Configuration
This section provides instructions for configuring transform sets on the system.
Important:
This section provides the minimum instruction set for configuring transform set on your system. For
more information on commands that configure additional parameters and options, refer to the Context Configuration
Mode Commands and Crypto Transform Configuration Mode chapters in the Command Line Interface Reference.
Mode Commands and Crypto Transform Configuration Mode chapters in the Command Line Interface Reference.
To configure the crypto transform set for IPSec:
Step 1
Configure crypto transform set by applying the example configuration in the
Step 2
Verify your Crypto Transform Set configuration by following the steps in the
Step 3
Save your configuration as described in the Verifying and Saving Your Configuration chapter.
Configuring Transform Set
Use the following example to create the crypto transform set on your system:
Notes:
<
> is the system context in which you wish to create and configure the crypto transform set(s).
<
> is the name of the crypto transform set in the current context that you want to configure
for IPSec configuration.
For more information on parameters, refer to the IPSec Transform Configuration Mode Commands chapter in
the Command Line Interface Reference.