Техническая Инструкция для Cisco Cisco Nexus 5010 Switch

flags: enabled

active aggr, aggr port: e1b

input packets 766192514, input bytes 2560966346135

input lacp packets 410301, output lacp packets 410438

output packets 615632, output bytes 81875375

up indications 9, broken indications 5

drops (if) 0, drops (link) 1

indication: up at 28Sep2014 00:48:23

consecutive 0, transitions 14

, since 28Sep2014 00:48:22 (142+11:23:02)

mediatype: auto-10g_twinax-fd-up

flags: enabled

active aggr, aggr port: e1b

input packets 246965410, input bytes 702882508932

input lacp packets 410301, output lacp packets 410442

output packets 615646, output bytes 81876343

up indications 9, broken indications 5

drops (if) 0, drops (link) 2

indication: up at 28Sep2014 00:48:22

consecutive 0, transitions 15

Use this section to confirm that your configuration works properly.

The 

 (

 customers only) supports certain show commands. Use the

Cisco CLI Analyzer in order to view an analysis of show command output.

The Verify and Troubleshoot sections of this document center around Nexus 5000 switches since
they are central to this configuration. 

bdsol-n5548-05# show int vfc 105

vfc105 is trunking

Bound interface is port-channel105

Hardware is Ethernet

Port WWN is 20:68:00:2a:6a:28:68:7f

snmp link state traps are enabled

Port mode is TF

Port vsan is 70

Trunk vsans (admin allowed and active) (70)

Trunk vsans (isolated) ()

Trunk vsans (initializing) ()

1 minute input rate 0 bits/sec, 0 bytes/sec, 0 frames/sec

1 minute output rate 0 bits/sec, 0 bytes/sec, 0 frames/sec

65 frames input, 6904 bytes

0 discards, 0 errors

65 frames output, 9492 bytes

0 discards, 0 errors

The previous output shows that VSAN 70 is up and trunks on VFC and that it does indeed operate
in the expected mode - TF.

Check the flogi database on the switches.