Техническая Инструкция для Cisco Cisco Aironet 350 Wireless Bridge
root(config−ssid)#guest−mode
The guest−mode command configures the SSID to be broadcasted by the root AP.
In order to configure the radio role to be the root and add the SSID under the radio, enter:
root(config)#interface dot11Radio 0
root(config−if)#station−role root
root(config−if)#ssid wgb
root(config−if)#station−role root
root(config−if)#ssid wgb
2.
Verify
In order to look at the clients connected to the root AP, enter the show dot11 associations command. A
sample ouput is shown here:
sample ouput is shown here:
root#show dot11 associations
802.11 Client Stations on Dot11Radio0:
SSID [wgb] :
IPV6
MAC Address IP address address Device Name Parent State
4c00.82df.c1ad 10.105.132.173 :: WGB wgb self Assoc <−WGB
entry
68bc.0c5a.df01 10.105.132.174 :: WGB−client − 4c00.82df.c1ad Assoc <−Wired
client entry
6c41.6a78.d832 10.105.132.175 :: WGB−client − 4c00.82df.c1ad Assoc <−Wired
client entry
In order to verify the parent that the WGB connects to, enter the show dot11 associations command:
wgb#show dot11 associations
wgb#show dot11 associations
802.11 Client Stations on Dot11Radio0:
SSID [wgb] :
IPV6
MAC Address IP address address Device Name Parent State
ccd5.39e3.b260 10.105.132.133 :: ap1260−Parent root − Assoc
There can be times when, even though the wired client is shown as associated, you are not be able to pass
traffic to it. This could be because the WGB has removed the client entry from its forwarding table. This can
happen if the wired client does not send any traffic for the timeout period. You can find the list of active
clients with the show bridge command:
traffic to it. This could be because the WGB has removed the client entry from its forwarding table. This can
happen if the wired client does not send any traffic for the timeout period. You can find the list of active
clients with the show bridge command:
wgb#show bridge
Total of 300 station blocks, 292 free
Codes: P − permanent, S − self
Bridge Group 1:
Address Action Interface Age RX count TX count
68bc.0c5a.df01 forward Vi0 0 43 20
6c41.6a78.d832 forward Vi0 0 29 12
Troubleshoot
This section provides information you can use to troubleshoot your configuration. Complete these checks if
WGB does not associate to the AP.
WGB does not associate to the AP.
Check if the configurations match between the AP and the WGB. Make sure SSID, Security settings,
•