Cisco Cisco Aironet 350 Wireless Bridge 기술 매뉴얼

root(config−ssid)#guest−mode

The guest−mode command configures the SSID to be broadcasted by the root AP.

In order to configure the radio role to be the root and add the SSID under the radio, enter:

root(config)#interface dot11Radio 0
root(config−if)#station−role root
root(config−if)#ssid wgb

2. 

In order to look at the clients connected to the root AP, enter the show dot11 associations command. A
sample ouput is shown here:

root#show dot11 associations

802.11 Client Stations on Dot11Radio0:

SSID [wgb] :

                                IPV6

MAC Address    IP address      address Device      Name  Parent          State

4c00.82df.c1ad  10.105.132.173   ::     WGB         wgb   self            Assoc  <−WGB

68bc.0c5a.df01  10.105.132.174   ::     WGB−client   −    4c00.82df.c1ad  Assoc  <−Wired

6c41.6a78.d832  10.105.132.175   ::     WGB−client   −    4c00.82df.c1ad  Assoc  <−Wired

In order to verify the parent that the WGB connects to, enter the show dot11 associations command:
wgb#show dot11 associations

802.11 Client Stations on Dot11Radio0:

SSID [wgb] :

                                  IPV6

MAC Address      IP address      address    Device        Name       Parent     State

ccd5.39e3.b260   10.105.132.133    ::      ap1260−Parent  root         −        Assoc

There can be times when, even though the wired client is shown as associated, you are not be able to pass
traffic to it. This could be because the WGB has removed the client entry from its forwarding table. This can
happen if the wired client does not send any traffic for the timeout period. You can find the list of active
clients with the show bridge command:

wgb#show bridge

Total of 300 station blocks, 292 free

Codes: P − permanent, S − self

Bridge Group 1:

Address         Action    Interface Age RX count TX count

68bc.0c5a.df01  forward    Vi0        0     43       20

6c41.6a78.d832  forward    Vi0        0     29       12

This section provides information you can use to troubleshoot your configuration. Complete these checks if
WGB does not associate to the AP.

Check if the configurations match between the AP and the WGB. Make sure SSID, Security settings,

•