Руководство По Установке для Cisco Cisco AP541N Wireless Access Point
Cisco AP541N Dual-band Single-radio Access Point Quick Start Guide
11
Prepare the Device
To prepare the device, do the following:
S
TEP
1
Attach the antennas to the RP-SMA connectors labeled ANT101,
ANT102, and ANT103. The antennas are all the same, so which
antenna is attached to what connector is of no consequence.
ANT102, and ANT103. The antennas are all the same, so which
antenna is attached to what connector is of no consequence.
S
TEP
2
Determine where you want to locate the access point. If you are
using AC power, make sure the location is within reach of an AC
power outlet.
using AC power, make sure the location is within reach of an AC
power outlet.
S
TEP
3
Keep enough ventilation space for the access point and check for
any other environmental restrictions.
any other environmental restrictions.
Wall Mounting
Before you begin, you need 2 wallboard screws (included) to mount the
access point. We recommend using screws with a minimum of 4mm width
at the head and a shaft diameter of at least 1.5mm.
access point. We recommend using screws with a minimum of 4mm width
at the head and a shaft diameter of at least 1.5mm.
W
ARNING
Insecure mounting might damage the device or cause injury.
Cisco is not responsible for damages incurred by insecure wall-
mounting.
Cisco is not responsible for damages incurred by insecure wall-
mounting.
To mount the access point to the wall:
S
TEP
1
Determine where you want to mount the access point. Verify that
the surface is smooth, flat, dry, and sturdy.
the surface is smooth, flat, dry, and sturdy.
S
TEP
2
Drill two pilot holes into the surface 5.75 inches (146 mm) apart,
and with a minimum of 4.0 inches (101 mm) of clearance.
and with a minimum of 4.0 inches (101 mm) of clearance.
S
TEP
3
Insert a screw into each hole, leaving a gap between the surface
and the base of the screw head of at least 0.1 inches (3 mm).
and the base of the screw head of at least 0.1 inches (3 mm).
S
TEP
4
Place the access point wall-mount slots over the screws and slide
the access point down until the screws fit snugly into the wall-
mount slots.
the access point down until the screws fit snugly into the wall-
mount slots.