Руководство Администратора для Cisco Cisco Packet Data Gateway (PDG)
Gx Interface Support
Rel. 6 Gx Interface ▀
Cisco ASR 5x00 Home Agent Administration Guide ▄
121
Optional: To configure action on packets that do not match any policy gates in the general purpose PDP context,
in the IMS Authorization Service Configuration Mode, enter the following command:
traffic-policy general-pdp-context no-matching-gates direction { downlink | uplink
} { forward | discard }
} { forward | discard }
Optional: To configure the algorithm to select Diameter host table, in the Policy Control Configuration Mode,
enter the following command:
diameter host-select table { 1 | 2 } algorithm { ip-address-modulus | msisdn-
modulus | round-robin }
modulus | round-robin }
Verifying IMS Authorization Service Configuration
To verify the IMS Authorization Service configuration:
Step 1
Change to the context where you enabled IMS Authorization Service by entering the following command:
context <context_name>
Step 2
Verify the IMS Authorization Service’s configurations by entering the following command:
show ims-authorization service name <imsa_service_name>
Applying IMS Authorization Service to an APN
After configuring IMS Authorization service at the context-level, an APN must be configured to use the IMS
Authorization service for an IMS subscriber.
Authorization service for an IMS subscriber.
Use the following example to apply IMS Authorization service functionality to a previously configured APN within the
context configured in the
context configured in the
configure
context <context_name>
apn <apn_name>
ims-auth-service <imsa_service_name>
end
Notes:
<context_name>
must be the name of the context in which the IMS Authorization service was configured.
<imsa_service_name>
must be the name of the IMS Authorization Service configured for IMS authentication
in the context.
Verifying Subscriber Configuration
Verify the IMS Authorization Service configuration for subscriber(s) by entering the following command:
show subscribers ims-auth-service <imsa_service_name>
<imsa_service_name>
must be the name of the IMS Authorization Service configured for IMS authentication.