для Cisco Cisco Packet Data Gateway (PDG)
Management Settings
SNMP Support ▀
ASR 5000 System Administration Guide, StarOS Release 16 ▄
87
SNMP Support
The system uses the SNMP to send traps or events to the Web Element Manager server or an alarm server on the
network. You must configure SNMP settings to communicate with those devices.
network. You must configure SNMP settings to communicate with those devices.
Important:
Commands used in the configuration samples in this section provide base functionality. The most
common commands and keyword options are presented. In many cases, other optional commands and keyword options
are available. Refer to the Command Line Interface Reference for complete information.
are available. Refer to the Command Line Interface Reference for complete information.
The SNMP MIB Reference describes the MIBs and SNMP traps supported by the ASR 5x00 platform.
To configure the system to communicate with the WEM server or an alarm server:
Step 1
Set SNMP parameters such as UDP port, and alarm server target by applying the example configuration in
Step 2
Step 3
Save the configuration as described in Verifying and Saving Your Configuration.
Configuring SNMP and Alarm Server Parameters
Use the following example to set SNMP and alarm server parameters:
configure
system contact <contact_name>
system location <location_name>
snmp authentication-failure-trap
snmp community <community_string>
snmp server port <port_number>
snmp target <name ip_address>
snmp engine-id local <id_string>
snmp notif-threshold <value> low <low_value> period <time_period>
snmp user <user_name>
snmp mib <mib_name>
end