Примечания к выпуску для Cisco Cisco Aironet 350 Wireless LAN Client Adapter
3
Release Notes for Cisco Aironet Client Adapter Drivers, Version 1.5.2 for Linux
OL-1348-01
Upgrading to a New Driver Release
Step 11
When you are asked if you are using a RedHat 7.1 system with an unmodified kernel, perform one of the
following:
following:
•
If you are not using a RedHat 7.1 system and your distribution does not enable PCMCIA support in
the kernel by default, type n, press Enter, and go to Step 12.
the kernel by default, type n, press Enter, and go to Step 12.
•
If you are not using a RedHat 7.1 system but your distribution enables PCMCIA support in the
kernel by default, follow the instructions in the “Option 3 for RedHat 7.1 Systems” section on
page 7.
kernel by default, follow the instructions in the “Option 3 for RedHat 7.1 Systems” section on
page 7.
•
If you are using a RedHat 7.1 system, type y (lowercase), press Enter, and go to the “Installation
Instructions for RedHat 7.1 Systems” section on page 4.
Instructions for RedHat 7.1 Systems” section on page 4.
Note
If you do not enter a lowercase y, your response is treated as negative.
Step 12
When you are asked if you already have pcmcia-cs-3.1.26.tar.gz (the source for Card and Socket
Services) or greater unpacked, perform one of the following:
Services) or greater unpacked, perform one of the following:
•
If you do not already have Card and Socket Services unpacked, follow the steps below:
a.
Type n and press Enter.
b.
Follow the instructions on the screen to obtain the source for Card and Socket Services; then
follow the instructions to unpack it.
follow the instructions to unpack it.
c.
Retype sh ./cwinstall and press Enter to return to the installation process. You are returned to
the part of the installation that asks if you are using a RedHat 7.1 system.
the part of the installation that asks if you are using a RedHat 7.1 system.
d.
Follow the instructions in Step 11 to answer the RedHat question. If you type n, you are again
asked if you already have pcmcia-cs-3.1.26.tar.gz or greater unpacked. This time type y and
press Enter.
asked if you already have pcmcia-cs-3.1.26.tar.gz or greater unpacked. This time type y and
press Enter.
e.
•
If you already have Card and Socket Services unpacked, type y, press Enter, and go to Step 13.
Step 13
When prompted, type in the path to Card and Socket Services and press Enter. The driver is copied, and
instructions display for building and installing the driver.
instructions display for building and installing the driver.
Note
You may want to open another session so you can refer to the instructions on the
screen.
screen.
Step 14
Change to the directory where the source of Card and Socket Services was unpacked. The exact path,
which was determined by the information you provided earlier, is included in the on-screen instructions.
Type in the cd command exactly as it appears.
which was determined by the information you provided earlier, is included in the on-screen instructions.
Type in the cd command exactly as it appears.
Step 15
Type make config.
Step 16
Press Enter to accept all defaults.
Step 17
If it configures without errors, type make all.
Step 18
If it builds without errors, type make install. The driver is now compiled and installed.
Step 19
Insert your PC card or PCI client adapter into the computer.