Примечания к выпуску для Cisco Cisco Aironet 1200 Access Point
6
Release Notes for Cisco Aironet 1100, 1130, 1200, 1230, 1240, and 1300 Series Access Points for Cisco IOS Release 12.3(11)JX1
OL-10752-02
Installation Notes
Caution
The nominal voltage for 1200 series access points is 48 VDC, and the access point is operational up to
60 VDC. Voltage higher than 60 VDC can damage the equipment.
60 VDC. Voltage higher than 60 VDC can damage the equipment.
Caution
Cisco Aironet power injectors are designed for use with Cisco Aironet access points and bridges only.
Do not use the power injector with any other Ethernet-ready device. Using the power injector with other
Ethernet-ready devices can damage the equipment.
Do not use the power injector with any other Ethernet-ready device. Using the power injector with other
Ethernet-ready devices can damage the equipment.
Use Only One Power Option
You cannot provide redundant power to 1100, 1130AG, nd 1200 series access points with both DC power
to its power port and inline power from a patch panel or powered switch to the access point’s Ethernet
port. If you apply power to the access point from both sources, the switch or power patch panel might
shut down the port to which the access point is connected.
to its power port and inline power from a patch panel or powered switch to the access point’s Ethernet
port. If you apply power to the access point from both sources, the switch or power patch panel might
shut down the port to which the access point is connected.
shows the power configuration that
can shut down the port on the patch panel or powered switch.
Figure 1
Improper Power Configuration Using Two Power Sources
Configuring Power for 1130, 1230, and 1240 Access Points
The 1130, 1230, and 1240 access points disable the radio interfaces when the unit senses that the power
source to which it is connected does not provide enough power. Depending on your power source, you
might need to enter the power source type in the access point configuration. Use the System Software:
System Configuration page on the web-browser interface to select a power option.
source to which it is connected does not provide enough power. Depending on your power source, you
might need to enter the power source type in the access point configuration. Use the System Software:
System Configuration page on the web-browser interface to select a power option.
shows the
System Power Settings section of the System Configuration page.
Universal
power supply
SYST
RPS
DUPLX
MODE
SPEED
UTIL
STAT
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
23
24
10Base-T / 1
00Base-TX
100Base-FX
Catalyst 2950
SERIES
Switch with
inline power or
power patch panel
Access point
74329