Примечания к выпуску для Cisco Cisco Aironet 1200 Access Point
7
Release Notes for Cisco Aironet 350, 1100, 1130AG, 1200, and 1230AG Series Access Points for Cisco IOS Release 12.3(4)JA1
OL-8215-01
New Features
Support for Multiple Basic Service Set IDs
This feature permits a single access point to appear to the WLAN as multiple virtual access points. It
does this by assigning an access point with multiple Basic Service Set IDs (MBSSIDs) or MAC
addresses.
does this by assigning an access point with multiple Basic Service Set IDs (MBSSIDs) or MAC
addresses.
To determine whether a radio supports multiple basic SSIDs, enter the show controllers command for
the radio interface. The radio supports multiple basic SSIDs if the results include this line:
the radio interface. The radio supports multiple basic SSIDs if the results include this line:
Number of supported simultaneous BSSID on radio_interface: 8
Wi-Fi 802.11h and Dynamic Frequency Selection Support
This feature allows Cisco access points configured at the factory for use in Europe and Singapore to
detect radar signals such as military and weather sources and switch channels on the access points.
detect radar signals such as military and weather sources and switch channels on the access points.
Wireless IDS – Excess Management Frame Detection
This feature provides scanner access points the ability to detect that WLAN management and control
frames exceeded a configurable threshold.
frames exceeded a configurable threshold.
Wireless IDS – Authentication Attack Detection
This feature requires Cisco access points to detect and report on excessive attempted or failed
authentication attempts (Authentication failure detection and Excess EAPoL authentication).
authentication attempts (Authentication failure detection and Excess EAPoL authentication).
Frame Monitor Mode
This feature requires a Scan-only access point to forward all 802.11 frames seen to a protocol analysis
station for network troubleshooting from remote sites via partner applications or partner Intrusion
Detection companies or both.
station for network troubleshooting from remote sites via partner applications or partner Intrusion
Detection companies or both.
Location Based Services (LBS)
This feature enables a Cisco access point to detect frames from LBS tags and send them to a
pre-configured IP destination such as a third-party LBS server.
pre-configured IP destination such as a third-party LBS server.
SNMPv3
This feature enables SNMPv3 support on Cisco access points to provide an additional level of security.