Cisco Cisco Aironet 1200 Access Point Notas de publicación

This feature permits a single access point to appear to the WLAN as multiple virtual access points.  It 
does this by assigning an access point with multiple Basic Service Set IDs (MBSSIDs) or MAC 
addresses.

To determine whether a radio supports multiple basic SSIDs, enter the show controllers command for 
the radio interface. The radio supports multiple basic SSIDs if the results include this line:

Number of supported simultaneous BSSID on radio_interface: 8 

This feature allows Cisco access points configured at the factory for use in Europe and Singapore to 
detect radar signals such as military and weather sources and switch channels on the access points.

This feature provides scanner access points the ability to detect that WLAN management and control 
frames exceeded a configurable threshold.

This feature requires Cisco access points to detect and report on excessive attempted or failed 
authentication attempts (Authentication failure detection and Excess EAPoL authentication).

This feature requires a Scan-only access point to forward all 802.11 frames seen to a protocol analysis 
station for network troubleshooting from remote sites via partner applications or partner Intrusion 
Detection companies or both.

This feature enables a Cisco access point to detect frames from LBS tags and send them to a 
pre-configured IP destination such as a third-party LBS server.

This feature enables SNMPv3 support on Cisco access points to provide an additional level of security.