Руководство По Установке для Cisco Cisco Prime Network Registrar Jumpstart 8.2

After the server reboots, configure ESXi 5.1 in the KVM Console window. For more information on how 
to configure the ESXi layer, see 

Using VMware vSphere, connect to the IP address or hostname of the UCS (ESXi). 

From the vSphere menu, choose File > Deploy OVF Template.

The Deploy OVF Template Source window appears.

To deploy the OVF file, click Browse and choose the OVF file (.ovf) available on the location where it 
was previously unpacked. Choose the appropriate Local or Regional OVF in the corresponding 
subdirectory.

Complete the deployment following the on-screen instructions. See the “Deploying the Cisco Prime 
Network Registrar Virtual Appliance” procedure in the Cisco Prime Network Registrar 8.2 Installation 
Guide for details.

You might want to resize the data disk before starting the virtual machine since the Recovery DVD has 
the standard OVFs. For details regarding increasing the disk size, see the “Increasing the Size of Disk” 
procedure in the “Introduction to Cisco Prime Network Registrar Virtual Appliance” chapter of the Cisco 
Prime Network Registrar 8.2 User Guide.

Open the console for “NR-local-ucs” virtual machine and click the Power on button to power up the 
virtual machine. For more information, see 

.

Connect to Cisco Prime Network Registrar using http://. It prompts you to create an admin user and 
password for Cisco Prime Network Registrar.

You can now restore your original license or request a replacement license at 

If you encounter any issue for which you are not able to find a solution, contact the Cisco Technical 
Assistance Center (TAC) for help.

For assistance in troubleshooting, the appliance comes with a secure FTP server and a TAC tool.

Ensure that you send the data gathered by the TAC tool to the TAC team in case of issues. For more 
details regarding the TAC tool, see the Cisco Prime Network Registrar 8.2 User Guide.

You can use the FTP server (vsftpd) to transfer files to and from the virtual appliance. You have to create 
a user to log into the vsftpd because the 'root' user cannot be used for logging in. The vsftpd will not be 
up and running when you power on the appliance, so you have to manually start it.

You can start the vsftpd using the command:

You can stop the vsftpd using the command: