Руководство По Установке для Cisco Cisco Prime Network Registrar Jumpstart 8.2

Ensure that you have the Cisco Prime Network Registrar licenses from Cisco.com before you get started. 
For details, see the License Files section of Cisco Prime Network Registrar 8.2 Installation Guide.

Configuring Cisco Prime Network Registrar Jumpstart requires you to do the following configuration 
steps to connect it to the network:

To configure the Cisco Prime Network Registrar Jumpstart:

Configure the UCS CIMC Network Connection. To configure this, follow the steps in the Connecting 
and Powering On the Server (Standalone Mode) chapter of the enclosed Cisco UCS C220 Server 
Installation and Service Guide or you can see the document available online at 

You have to configure NIC Redundancy as None in the Connecting and Powering On (Standalone Mode) 
procedure.

The CIMC gives you insight into the hardware as well as support for a virtual KVM console allowing 
remote management of the ESXi layer. For details on CIMC, see the Cisco UCS C-Series Servers 
Integrated Management Controller GUI Configuration Guide available at 

After configuring the network information for the UCS CIMC console, use the virtual KVM console that 
the CIMC console provides to configure the network information for the ESXi hypervisor.

Use a browser to connect to the IP address of the CIMC console.

Log into the CIMC console.

The default username is admin and default password is password, but you should change the password 
at your earliest convenience.