Руководство По Установке для Cisco Headend System Release 2.5
78-738190-01 Rev B
Dialup Remote Access Configuration Procedures
C-3
Configure Dialup Remote Access,
Continued
Editing the Dialup String
Use the following procedure to edit the dialup string.
1.
From an xterm window on the DNCS, type su - and then press Enter.
Result: The password prompt appears.
Result: The password prompt appears.
2.
Type the root password and then press Enter.
Result: You have root permissions in the xterm window.
Result: You have root permissions in the xterm window.
3.
Type cd /etc/ppp/peers and then press Enter.
4.
Type vi sa.scr and then press Enter.
Result: The sa.scr file opens for editing.
Note: The file looks similar to the following:
ABORT
Result: The sa.scr file opens for editing.
Note: The file looks similar to the following:
ABORT
“NO CARRIER”
ABORT
“NO DIALTONE”
ABORT
“ERROR”
ABORT
“NO ANSWER”
ABORT
“BUSY”
“ “
“AT”
OK
“at&d2&c1”
OK
“atdt9,7705557890”
CONNECT “ “
~
~
~
“sa.scr”[Read Only] 9 lines, 139 Characters
5.
Scroll to the line that contains the OK “atdt9,7705557890” entry.
Note: The 9 is a prefix and the , (comma) signifies a pause.
Note: The 9 is a prefix and the , (comma) signifies a pause.
6.
Edit the file as required.
Note: In many cases, the Dialup Remote Access software requires a long
Note: In many cases, the Dialup Remote Access software requires a long
distance telephone call. You may require a prefix other than 9, or you may
need to precede the dialup string with a 1.
Important: Be sure to save the file and exit the vi editor when you complete
Important: Be sure to save the file and exit the vi editor when you complete
this procedure.
7.
Type exit and then press Enter to exit your UNIX session.