Руководство По Установке для Cisco DNCS System Release 2.7 3.7 4.2
Download Software to the Individual Test DHCTs
Error! No text of specified style in document.
51
Download Software to the Individual Test DHCTs
This section contains procedures for downloading software to the test DHCTs.
Note: The following test configuration requires that test DHCTs are In Service Two
Note: The following test configuration requires that test DHCTs are In Service Two
Way and are connected to a functioning two-way RF cable drop. You can confirm
this by viewing Page 4 diagnostic screen and verifying that the DHCT has an IP
address.
Downloading Software to Individual Test DHCTs
1 Unplug the power cord from the back of the DHCT.
2 Press and hold the VOL – key on the DHCT while plugging the power cord into
2 Press and hold the VOL – key on the DHCT while plugging the power cord into
the back of the DHCT. The DHCT boots into Guardian mode.
3 Press the Power button on the DHCT you are testing.
Results:
The DHCT reads the index file.
The DHCT loads the _0 ROM file and reboots back into Guardian mode.
4 Press the Power button again on the DHCT you are testing.
Results:
The DHCT reads the index file.
The DHCT loads the _1 ROM file and reboots back into Guardian mode.
5 When the download is complete, verify that the test DHCT operates as expected.
6 Repeat steps 1 through 5 for each test DHCT, and then go to step 7.
7 Complete one of the following options:
6 Repeat steps 1 through 5 for each test DHCT, and then go to step 7.
7 Complete one of the following options:
If you have DHCTs to test for CVT, go to Phase Two CVT Checklist (on page
If you do not have DHCTs to test for CVT, go to Phase Three - Install New
Software (on page 63).