Руководство По Обслуживанию для Cisco Cisco StadiumVision Mobile Streamer
© 2011 Cisco Systems, Inc. All rights reserved.
Page 62 of 103
To configure RS-232 serial commands:
1. Open the Serial Commands tab:
Figure 45.
Serial Commands Screen
2. From the Available Serial Commands list, select the command or commands
that you wish to add and click <<. This adds the command name to the list of
Configured Serial Commands.
Configured Serial Commands.
3. If the command you wish to configure is not in the list of Available Serial
Commands, click the + at the upper right of the list box and enter the label you
wish to use for the new command. Then click << to add the command to the list
of Configured Serial Commands.
wish to use for the new command. Then click << to add the command to the list
of Configured Serial Commands.
4. Highlight the serial command in the Configured Serial Commands list.
5. Click the + above the Serial Strings of Selected Commands list.
6. Enter the appropriate serial string. This string will now be associated with the
highlighted serial command for this device.
Defining External Volume Commands
When using external volume control you must configure RS-232 commands to send
to the TV when changing volume. Volume commands do not need to be configured
when internal volume control is used.
to the TV when changing volume. Volume commands do not need to be configured
when internal volume control is used.
StadiumVision Director allows you to define volume controls that are relative
(volume up and volume down) or absolute (volume number). Relative volume
commands depend on the volume increments set in the TV, which may vary widely
from model to model. Therefore, the preferred method is to use absolute volume
controls.
(volume up and volume down) or absolute (volume number). Relative volume
commands depend on the volume increments set in the TV, which may vary widely
from model to model. Therefore, the preferred method is to use absolute volume
controls.