Руководство По Установке для Cisco Cisco Content Security Management Appliance M160
10
•
To access the CLI remotely, initiate an SSH session
to the IP address 192.168.42.42.
to the IP address 192.168.42.42.
Step 2
Log in as admin with the password ironport.
Step 3
At the prompt, run the systemsetup command.
10
Run the System Setup Wizard
Run the System Setup Wizard to configure basic settings and
enable a set of system defaults. The System Setup Wizard starts
automatically when you access the appliance via the web-based
interface (or when you run the systemsetup command from the
command-line interface.)
enable a set of system defaults. The System Setup Wizard starts
automatically when you access the appliance via the web-based
interface (or when you run the systemsetup command from the
command-line interface.)
Step 1
Accept the end user license agreement.
Step 2
Enter system and network information from the
If you need additional information about the settings,
choose Help and Support > Online Help.
choose Help and Support > Online Help.
Step 3
Review the configuration summary page.
Step 4
Click Install this Configuration.
The appliance may not appear to have accepted your
configuration or be performing the installation. This is
because you have changed the IP address, but the
installation is underway.
configuration or be performing the installation. This is
because you have changed the IP address, but the
installation is underway.
Step 5
If you temporarily changed the IP address of your
computer as described above, change the IP address
settings back to the original values.
computer as described above, change the IP address
settings back to the original values.
Step 6
Ensure that your laptop and the appliance are
connected to the network.
connected to the network.
Step 7
Log in to the appliance again, at the hostname or IP
address that you noted in the
address that you noted in the
. Use the username admin and the new
password that you entered in the wizard.
M690_QSG.fm Page 10 Thursday, March 31, 2016 5:43 PM