Руководство По Установке для Cisco Cisco TelePresence MX700

Configuring H.323 and SIP

(when not set by a provisioning system)

to get online and ready to place and receive calls, your system

must be set up properly. Your system uses either the H.323

protocol or the SiP protocol for video calls.

NoTe:

Contact your system administrator, or service provider,

for information about the network settings.

for networks administered through Cisco tMS (Cisco

telePresence Management Suite) your Cisco tMS adminis-

trator will help you to get online.

You can find information about admininistering through Cisco

uCM in the

guide.

H.323

if in doubt for any of the parameters below, contact your

system administrator or your service provider.

1. Go to the

tab and select

.

2. open the

settings from the left column.

3. under

heading and the

subheading, enter

the

and the

number in their respective input fields.

4. Go to the

subheading.

if you want the system to obtain the H.323 gatekeeper

address automatically, select

in the

drop

down list; if you want to enter the address manually, select

if set to

enter the gatekeeper

in the corre-

sponding input field.

5. if the H.323 gatekeeper requires authentication and you

want your system to authenticate itself to the gatekeeper,

go to the

subheading and select

in

the

drop down list. then enter the

and

in the corresponding input fields.

otherwise, select

in the

drop down list.

6. Click the

tab to see the

and

verify the H.323 settings.
if you successfully registered to a Gatekeeper the

is shown as

in the H323 section.

Please check the Administrator guide for your product if you

want to change the other H.323 settings.

SIP

if in doubt for any of the parameters below, contact your

system administrator or your service provider.

1. Go to the

tab and select

.

2. open the

page from the sidebar on the left.

3. under the

heading, enter the SiP uri in the

input field, and optionally a display name in the

input field.

4. Select the preferred transport protocol from the

drop down list. if you select

, the system

first tries to connect using tls, then tCP, and finally udP.

5. Select a proxy type in the

drop down list. the default

type is

.

6. Go to the

subheading.

if you want the system to obtain the SiP proxy address

automatically, select

in the

drop down list;

if you want to enter the address manually, select

.

if you select

enter the proxy

in the corre-

sponding input field.

7. if the SiP proxy requires authentication you must enter a

login name and password to authenticate your system. Go to

the

subheading and enter the

and

in the corresponding input fields.

8. Click the

tab to see the

and

verify the SiP settings.
if you successfully registered to a SiP server the

is

shown as

in the SiP section.

Please check the Administrator guide

for your product if you

want to change the other SiP settings.

If you are changing a value setting, 

you always have to click

to confirm the change.

Back to task overview

Cisco telePresence Video Systems

d14639.08 Video Systems Getting Started Guide tC6.0, february 2013.

Copyright © 2010–2013 Cisco Systems, inc. All rights reserved.

26

Getting Started Guide

Contents

Introduction

User interfaces

Configuration

Appendices

Contacts

Configuration