Руководство По Обслуживанию для Cisco Cisco TelePresence MX700
Cisco TelePresence Endpoints and Cisco Unified Communications Manager
Quick Reference Guide
D14996.09 Administering TC7.2 Endpoints on CUCM 10.5.1, NOVEMBER 2014.
www.cisco.com — Copyright © 2014 Cisco Systems, Inc. All rights reserved.
43
Endpoint configuration in three steps
Setting the system password
It is mandatory to set a password for the users to restrict
It is mandatory to set a password for the users to restrict
access to system configuration. If no password is set there
will be a notification on screen.
Go to:
Setting the call details
The call rate will not be set by CUCM. Set the call rate to
The call rate will not be set by CUCM. Set the call rate to
match the network capabilities to achieve the desired call
quality.
Go to:
Setting up provisioning
The endpoint can be provisioned either from CUCM, or from
The endpoint can be provisioned either from CUCM, or from
CUCM via Expressway.
Go to:
About endpoint configuration
This section gives an overview of the steps required for
registering a TelePresence endpoint to CUCM.
You can use the Touch controller, remote control, web
interface, or the command line interface to configure the
endpoint. Your TelePresence system is shipped with either a
Touch panel or a remote control.
NOTE:
We recommend doing the CUCM configuration before
the endpoint provisioning.
Be aware that HTTP (web interface) and SSH (used for
command line) may be disabled in the endpoint configuration
on CUCM. This will prevent access to the endpoint's web
interface and command line interface. See
on page 21 how to enable/disable
Web access and SSH access.
Endpoint diagnostic tools
If having trouble using the TelePresence endpoint diagnostic
tools when the endpoint is provisioned to CUCM, check that
the SIP listen port is set to Off (default). Log in to the web
interface of the endpoint and go to: Configuration > System
Configuration > SIP > ListenPort.
Finding the IP address
If using the web interface or the command line interface you
will need the IP address of the endpoint.
Use the Touch controller or remote control to find the address.
• Using the Touch controller: Tap the upper left corner
of the Touch panel, followed by Settings > System
Information. Then see the General section.
• Using the remote control: Navigate to Home > Settings >
System Information and see the Network section.
Contents
Introduction
CUCM configuration
Endpoint configuration
About passwords
Appendices
Endpoint configuration