Руководство По Работе для Brother CS7130

1

2

3

4

5

1 

Wrong side

2 

Surface

3 

Upper thread

4 

Lower thread

5 

Loops appear on 

surface of fabric

Solution
Reduce the tension by turning the upper tension-
control dial to a lower number.

• When you finish sewing, remove the bobbin 

cover and then make sure that the thread is shown 

as below. If the thread is not shown as below, 

the thread is not inserted through the tension-

adjusting spring of the bobbin case correctly. 

Reinsert the thread correctly. For details, refer to 

page 14, 15.

■

Loops appear on the wrong side of the fabric.

• If the upper thread was incorrectly threaded, the 

upper thread may be too loose. In this case, refer 

to “Upper threading” (page 15) and rethread 

the upper thread.

1

2

3

4

5

1 

Wrong side

2 

Surface

3 

Upper thread

4 

Lower thread

5 

Loops appear on 

wrong

Solution
Increase the tension by turning the upper tension-
control dial to a higher number.

Various ways to achieve better results for your 
sewing projects are described below. Refer to these 
tips when sewing your project.

A trial piece of fabric should be sewn. Use a piece of
fabric and thread that are the same as those used for
your project, and check the thread tension and stitch
length and width.

When the stitching reaches a corner, stop the 
sewing machine.
Leave the needle lowered (in the fabric). 
If the needle was raised, lower the needle 
either by turning the handwheel toward you 
(counterclockwise) or by pressing   once.

Raise the presser foot lever, and then turn the 
fabric.
Turn the fabric using the needle as a pivot.