Инструкция С Настройками для Brother Innov-is VQ3000

1

Before start sewing, test the pattern first from steps 

a

 to 

e

 to see if the stitch can be used with this 

function. Before starting to sew, mark the end 
point.

a

b

c

d

→ The sensor functions screen appears.

e

→ The sewing end point setting screen appears.

The procedures to specify the sewing end point using the sensor pen differ from 
those described in the Operation Manual. Refer to the following.
We recommend that you keep this manual with the Operation Manual.

Note

• In order to specify the location accurately, use the sensor pen to touch the end point twice. Be sure to 

touch the same point.

• Before starting to sew, mark the end point.

Note

• If the needle drop point is being specified 

with the sensor pen within 70 mm (approx. 
2-3/4 inches) from the sewing end point, the 
machine will not require the second touch. 
After completing step 

f

, continue with 

step 

j

. However, the actual sewing end 

point may be slightly different than the 
specified location.
In order to specify the location accurately, 
stop the machine at a location more than 
70 mm (approx. 2-3/4 inches) away from 
the sewing end point before specifying it for 
the first time.

Memo

• If the needle drop point is greater than 

100 mm (approx. 4 inches) from the 
selected ending point using the sensor pen, 
a more accurate position can be specified 
the second time that the point is touched.

Note

• If 

 is not available, the sewing end 

point cannot be specified with the selected 
stitch pattern. Select a different stitch 
pattern.