Руководство По Работе для Brother Innov-is NQ550PRW / Innov-is NQ550

Winding/Installing the Bobbin

GE
T

G RE

Basic operations B-13

Winding the bobbin

This section describes how to wind thread onto a bobbin.

Open the top cover.

Place the bobbin on the bobbin winder shaft so that the
spring on the shaft fits into the notch in the bobbin

Press down on the bobbin until it snaps into place.

1 Notch
2 Bobbin winder shaft spring

Slide the bobbin winder in the direction of the arrow
until it snaps into place.

• The “Start/Stop” button lights up in orange.

Winding/Installing the Bobbin

CAUTION

• Only use the Bobbin (part code: SA156, SFB:

XA5539-151) designed specifically for this
machine. Use of any other bobbin may result
in injuries or damage to the machine.

• The included bobbin was designed specifically

for this machine.
If bobbins from other models are used, the
machine will not operate correctly. Use only
the included bobbin or bobbins of the same
type (part code: SA156, SFB: XA5539-151).
SA156 is Class15 type bobbin.

Made of plastic

1 This model
2 Other models
3 11.5 mm (approx. 7/16 inch)

Memo

• When the foot controller is connected, bobbin

winding can be started and stopped with the foot
controller.

Memo

• The shape of the bobbin winder guide post will

differ depending on your model; however, this
should not affect the operating procedure.
This manual describes the procedure for models
with a key-shaped bobbin winder guide post.

1 Bobbin winder guide post (oval)

1 Bobbin winder guide post (key)