Руководство По Работе для Brother Innov-is XV8500D
SEWING THE STITCHES
U
tili
ty
ty
S
tit
ch
es
145
3
Tape or Elastic Attaching
a
Select a straight stitch and attach presser
foot “J”.
foot “J”.
b
Set the stitch length to 4.0 mm (approx.
3/16 inch), and loosen the upper thread
tension to 2.0 (see “Setting the Stitch
Length” on page 91 and “Setting the Thread
Tension” on page 92).
3/16 inch), and loosen the upper thread
tension to 2.0 (see “Setting the Stitch
Length” on page 91 and “Setting the Thread
Tension” on page 92).
c
Sew two rows of straight stitches on the
right side of the fabric, then pull the bobbin
thread to create the necessary gather.
right side of the fabric, then pull the bobbin
thread to create the necessary gather.
d
Place the tape over the gather, and hold it
in place with basting pins.
in place with basting pins.
a Tape
e
Select
or .
f
Sew over the tape (or elastic).
g
Pull out the straight stitch threads.
Memo
• Be sure that neither automatic
reinforcement
nor automatic thread
cutting
is selected.
Memo
• Before sewing the straight stitch, rotate the
handwheel toward you (counterclockwise)
and pull up the bobbin thread. Holding the
top and bobbin thread, pull a length of
thread out from the rear of the machine. (Be
sure that the presser foot is raised.)
and pull up the bobbin thread. Holding the
top and bobbin thread, pull a length of
thread out from the rear of the machine. (Be
sure that the presser foot is raised.)
Memo
• For details on each stitch, refer to the
“STITCH SETTING CHART” at the end of
this manual.
this manual.
CAUTION
• Be sure the needle does not strike a basting
pin, or any other objects, during sewing. The
thread could tangle or the needle could break,
causing injury.
thread could tangle or the needle could break,
causing injury.