Руководство По Работе для Brother Innov-is XV8500D
TROUBLESHOOTING
396
Fabric is Caught in the Machine
and Cannot be Removed
and Cannot be Removed
If the fabric is caught in the sewing machine and
cannot be removed, the thread may have become
tangled under the needle plate. Follow the
procedure described below to remove the fabric
from the machine. If the operation could not be
completed according to the procedure, instead of
attempting to complete it forcefully, contact your
authorized Brother dealer or the nearest Brother
authorized service center.
cannot be removed, the thread may have become
tangled under the needle plate. Follow the
procedure described below to remove the fabric
from the machine. If the operation could not be
completed according to the procedure, instead of
attempting to complete it forcefully, contact your
authorized Brother dealer or the nearest Brother
authorized service center.
■ Removing the fabric from the
machine
a
Immediately stop the sewing machine.
b
Turn off the sewing machine.
c
Remove the needle.
If the needle is lowered into the fabric, turn the
handwheel away from you (clockwise) to raise the
needle out of the fabric, and then remove the needle.
handwheel away from you (clockwise) to raise the
needle out of the fabric, and then remove the needle.
*
Refer to “CHANGING THE NEEDLE” on page 75.
d
Remove the presser foot and presser foot
holder.
holder.
*
Refer to “CHANGING THE PRESSER FOOT” on
page 70.
page 70.
e
Lift up the fabric and cut the threads below
it.
it.
If the fabric can be removed, remove it. Continue with
the following steps to clean the race.
the following steps to clean the race.
f
Remove the needle plate cover.
a Needle plate cover
g
Cut out the tangled threads, and then
remove the bobbin.
remove the bobbin.
h
Remove the bobbin case.
If threads remain in the bobbin case, remove them.
a Bobbin case
i
Use the cleaning brush or a vacuum cleaner
to remove any dust or loose threads from
the race and its surrounding area.
to remove any dust or loose threads from
the race and its surrounding area.
a Cleaning brush
b Race
j
Use the enclosed multi-purpose screwdriver
to loosen the two screws on the needle
plate.
to loosen the two screws on the needle
plate.
If the fabric could be removed
Continue with
step
step
p
.
If the fabric could not be
removed
removed
Continue with
step
step
j
.
Note
• Be careful not to drop the removed screws
in the machine.