Руководство По Работе для Brother Innov-is XV8500D
TROUBLESHOOTING
398
q
Insert the tabs on the needle plate cover
into the needle plate, and then slide the
cover back on.
into the needle plate, and then slide the
cover back on.
r
Check the condition of the needle, and then
install it.
install it.
If the needle is in a poor condition, for example, if it is
bent, be sure to install a new needle.
bent, be sure to install a new needle.
*
Refer to “CHANGING THE NEEDLE” on page 75.
■ Checking machine operations
If the needle plate has been removed, check
machine operations to confirm that installation has
been completed correctly.
machine operations to confirm that installation has
been completed correctly.
a
Turn on the machine.
b
Select .
c
Slowly turn the handwheel toward you
(counterclockwise), and look from all sides
to check that the needle falls at the center
of the hole in the needle plate.
(counterclockwise), and look from all sides
to check that the needle falls at the center
of the hole in the needle plate.
If the needle contacts the needle plate, remove the
needle plate, and then install it again, starting with
step
needle plate, and then install it again, starting with
step
m
in “Removing the fabric from the machine” on
page 396.
a Hole in the needle plate
b Handwheel
b Handwheel
d
Select zigzag stitch
. At this time,
increase the stitch length and width to their
maximum settings.
maximum settings.
e
Slowly turn the handwheel toward you
(counterclockwise) and check that the
needle bar and feed dogs operate correctly.
(counterclockwise) and check that the
needle bar and feed dogs operate correctly.
If the needle or feed dogs contact the needle plate, the
machine may be malfunctioning; therefore, contact
your authorized Brother dealer or the nearest Brother
authorized service center.
machine may be malfunctioning; therefore, contact
your authorized Brother dealer or the nearest Brother
authorized service center.
f
Turn off the machine, and then install the
bobbin and presser foot.
bobbin and presser foot.
*
Refer to “Setting the Bobbin” and “CHANGING THE
PRESSER FOOT” on page 70.
PRESSER FOOT” on page 70.
g
Correctly thread the machine.
*
For details on the machine, refer to “UPPER
THREADING” on page 62.
THREADING” on page 62.
h
Perform trial sewing with normal fabric.
Note
• If the needle plate has been removed it is
especially important to reinstall the needle
plate and tighten the screws prior to
installing the bobbin case.
plate and tighten the screws prior to
installing the bobbin case.
CAUTION
• Never use bent needles. Bent needles can
easily break, possibly resulting in injuries.
Note
• After completing this procedure, continue
with the following procedure in “Checking
machine operations” to check that the
machine is operating correctly.
machine operations” to check that the
machine is operating correctly.
Memo
• Since the needle may have been damaged
when the fabric was caught in the machine,
we recommend replacing it with a new one.
we recommend replacing it with a new one.
Note
• Do not yet install the presser foot and
thread.
Note
• The thread may have become tangled as a
result of incorrect upper threading. Make
sure that the machine is correctly threaded.
sure that the machine is correctly threaded.
Note
• Remember when sewing thin fabrics, select
a center stitch that is shorter in length and
use the straight stitch needle plate for
straight sewing stitches. A lightweight
paper stabilizer can also be placed on the
underside of the fabric.
use the straight stitch needle plate for
straight sewing stitches. A lightweight
paper stabilizer can also be placed on the
underside of the fabric.