Руководство По Работе для Brother Innov-is XV8500D
CHANGING THE PRESSER FOOT
72
f
Set the operation lever of the walking foot
so that the needle clamp screw is set in the
fork. Position the shank of the walking foot
on the presser foot bar.
so that the needle clamp screw is set in the
fork. Position the shank of the walking foot
on the presser foot bar.
a Operation lever
b Needle clamp screw
c Fork
d Walking foot shank
c Fork
d Walking foot shank
e Presser foot bar
g
Lower the presser foot lever. Insert the
screw, and tighten the screw securely with
the screwdriver.
screw, and tighten the screw securely with
the screwdriver.
Using the Dual Feed Foot
Dual feed foot enables you to have best fabric
control when sewing difficult fabrics that slip
easily, such as quilted fabrics or fabrics that tend
to stick to the bottom of a presser foot, such as
vinyl, leather or synthetic leather.
control when sewing difficult fabrics that slip
easily, such as quilted fabrics or fabrics that tend
to stick to the bottom of a presser foot, such as
vinyl, leather or synthetic leather.
■ Attaching the Dual Feed Foot
a
Follow the steps in “Removing the Presser
Foot” on page 70.
Foot” on page 70.
b
Loosen the screw of the presser foot holder
to remove the presser foot holder.
to remove the presser foot holder.
a Multi- purpose screwdriver
b Presser foot holder screw
b Presser foot holder screw
c Presser foot holder
c
Position the dual feed foot to the presser
foot bar by aligning the notch of the dual
feed foot to the large screw.
foot bar by aligning the notch of the dual
feed foot to the large screw.
Side view
CAUTION
• Use the included screwdriver to tighten the
screw securely. If the screw is loose, the
needle may strike the presser foot and cause
injury.
needle may strike the presser foot and cause
injury.
• Be sure to rotate the handwheel toward you
(counterclockwise) to check that the needle
does not strike the presser foot. If the needle
strikes the presser foot, injury may result.
does not strike the presser foot. If the needle
strikes the presser foot, injury may result.
Note
• When sewing with the dual feed foot, sew at
medium to low speeds.
Memo
• When selecting stitches to be used with the
dual feed foot, only the stitches that can be
used will be activated on the display.
used will be activated on the display.
• When sewing fabric that easily sticks
together, a more attractive finish can be
achieved by basting the beginning of
sewing.
achieved by basting the beginning of
sewing.