Руководство По Работе для Brother Innov-is XV8550D
SEWING THE STITCHES
154
■ Darning
Use darning stitches for mending and other
applications.
applications.
Darning is performed by sewing from the front of the
presser foot to the back as shown below.
presser foot to the back as shown below.
a Reinforcement stitches
a
Select a stitch, and attach buttonhole foot
“A”.
“A”.
b
Set the scale to the desired length of the
darning.
darning.
a Presser foot scale
b Completed length measurement
b Completed length measurement
c Width 7 mm (approx. 1/4 inch)
d 5 mm (approx. 3/16 inch)
d 5 mm (approx. 3/16 inch)
c
Check that the needle drops at the desired
position and lower the presser foot, making
sure the upper thread passes underneath
the buttonhole foot.
position and lower the presser foot, making
sure the upper thread passes underneath
the buttonhole foot.
d
Lower the buttonhole lever so that it is
positioned behind the metal bracket on the
buttonhole foot.
positioned behind the metal bracket on the
buttonhole foot.
a Buttonhole lever
a Metal bracket
Stitch
Stitch name
Presser foot
Darning
Darning
Memo
• The maximum length for darning is 28 mm
(approx. 1-1/16 inches).
Note
• Pass the thread underneath the presser
foot.
• Set the presser foot so that there is no gap
behind the section marked with an “A” (the
shaded area in the illustration below). If
there is a gap, the size of the darning will
not be correct.
shaded area in the illustration below). If
there is a gap, the size of the darning will
not be correct.