Руководство По Работе для Brother NX 600
SEWING BASICS
— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
52
Memo
z The machine can be set so that the threads
will be cut when sewing is finished. For
details on setting the machine so that the
threads are cut automatically, refer to
"Automatically cutting the thread" (page 58).
details on setting the machine so that the
threads are cut automatically, refer to
"Automatically cutting the thread" (page 58).
■ Using the manual thread cutter
When sewing with thread thicker than #30, nylon
or metallic threads, or other special threads, use
the thread cutter on the side of the machine to cut
the threads.
or metallic threads, or other special threads, use
the thread cutter on the side of the machine to cut
the threads.
a
When you wish to finish the stitching and the
sewing machine is stopped, press
sewing machine is stopped, press
(Needle
position button) once to raise the needle.
a Needle position button
X
The needle is raised.
b
Raise the presser foot lever.
a Presser foot lever
c
Pull the fabric to the left side of the machine,
and then pass the threads through the thread
cutter to cut them.
and then pass the threads through the thread
cutter to cut them.
a Thread cutter
1
1
1
F3dash-BrotherE_sgml.book Page 52 Friday, September 5, 2003 5:46 PM