Руководство По Работе для Brother PR1050X
MY DESIGN CENTER WITH SCAN
18
Using the Scanning Frame
a
Prepare the desired drawing/illustration.
b
Position the paper to be scanned so that it is
aligned with the lower-left corner, securing
the paper in place with the magnets.
aligned with the lower-left corner, securing
the paper in place with the magnets.
*
Place the magnets at six locations around the paper
to secure it, making sure that the line drawing is not
covered.
to secure it, making sure that the line drawing is not
covered.
MY DESIGN CENTER WITH SCAN
CAUTION
• To avoid having the embroidery foot strike the
frame during the scanning process and
possibly causing injury, check the following:
the thickness of the fabric or paper, creases or
folds in the fabric or paper that may be rolled
up too close to the frame.
possibly causing injury, check the following:
the thickness of the fabric or paper, creases or
folds in the fabric or paper that may be rolled
up too close to the frame.
Memo
• Only one sheet of paper can be placed in
the scanning frame per scan.
Note
• The scanning area is 300 mm x 200 mm
(approx. 11-3/4 inches x 7-7/8 inches).
There are scan area marks with the frame.
Make sure that the paper is placed within
the mark. Any part of the image that is
outside the mark will not be scanned.
There are scan area marks with the frame.
Make sure that the paper is placed within
the mark. Any part of the image that is
outside the mark will not be scanned.
a 300 mm x 200 mm (approx. 11-3/4 inches x
7-7/8 inches) mark (maximum scanning field)
b Scan area
c Outside the scan area
2
3
1
1
Memo
• If you want to scan an image from a small
piece of paper that can't be held with the
magnets, copy that image onto a larger
piece of paper, to then be placed on the
scanning frame.
magnets, copy that image onto a larger
piece of paper, to then be placed on the
scanning frame.
Note
• When placing the paper in the scanning
frame, make sure that the white balance
area is not hidden; otherwise, the drawing
cannot be scanned correctly. At the same
time, be sure to place the scan image within
the scan area. The image out of the scan
area will not be scanned.
area is not hidden; otherwise, the drawing
cannot be scanned correctly. At the same
time, be sure to place the scan image within
the scan area. The image out of the scan
area will not be scanned.
a White balance area
b Scan area
• Make sure that the white balance area or
the scan area is not dirty or scratched;
otherwise, the image cannot be scanned
correctly.
otherwise, the image cannot be scanned
correctly.
• Be sure to use the magnets which are
included with the scanning frame. If any
other magnets are used, they may become
attached to the machine during scanning, or
other problems, such as a misaligned scan
image, may occur.
other magnets are used, they may become
attached to the machine during scanning, or
other problems, such as a misaligned scan
image, may occur.
• Be sure to place the magnets so that they
secure the paper firmly. If the paper is
placed unevenly, the image cannot be
scanned correctly.
placed unevenly, the image cannot be
scanned correctly.
• If the scanning frame is dirty, wipe it with a
cloth dampened with a diluted neutral
detergent solution.
detergent solution.