Руководство Пользователя для Brother PR-600/600C
7
ENGLISH
■ Adjusting the cylinder frame driver (only when
used for the first time)
1
L-shaped mounting bracket
2
Ring
3
Fitting in ring
Note
● Adjust the cylinder frame driver only when
it is being used for the first time. If the same
machine will be used, this adjustment will
not be required with later uses. However, if
the cylinder frame driver is used with a
different machine and the settings are
changed, the adjustment must be performed
again.
machine will be used, this adjustment will
not be required with later uses. However, if
the cylinder frame driver is used with a
different machine and the settings are
changed, the adjustment must be performed
again.
a
Set the main power switch to “I” to turn on
the machine. After the carriage moves to its
initial position, turn off the machine.
the machine. After the carriage moves to its
initial position, turn off the machine.
Memo
● Be sure to adjust the cylinder frame driver at
its initial position. For details on the initial
position, refer to the Operation Manual.
position, refer to the Operation Manual.
b
Using the enclosed Allen wrench (2.5 mm),
turn the two hexagonal screws one turn in
the direction of the arrow to loosen them.
When the hexagonal screws are loosened,
the fitting in the ring is lowered.
turn the two hexagonal screws one turn in
the direction of the arrow to loosen them.
When the hexagonal screws are loosened,
the fitting in the ring is lowered.
1
Hexagonal screws
2
Enclosed Allen wrench (2.5 mm)
3
Fitting in ring
Note
● Do not remove the hexagonal screws.
c
While lightly pressing down with your finger
on the L-shaped mounting bracket so that it
touches the top surface of the machine bed,
use the Allen wrench (2.5 mm) to firmly
tighten the two hexagonal screws.
on the L-shaped mounting bracket so that it
touches the top surface of the machine bed,
use the Allen wrench (2.5 mm) to firmly
tighten the two hexagonal screws.
1
L-shaped mounting bracket
2
Fitting in ring
Memo
● Firmly tighten the hexagonal screws so that
the fitting in the ring touches the surface of
the machine bed.
the machine bed.
a
b
c
a
2
3
a
2