Инструкция С Настройками для Brother PE-DESIGN Ver.4,3,2

42

Before you can actually sew your embroidery pattern, you must transfer it to an Original card.

1

Insert an Original card in the module.

2

Click 

 on the menu bar, then click 

 on the submenu.

You can also click on the button of the Toolbar shown below: 

This dialog will display.

If the card module is not correctly connected or powered, if the card is not inserted or is defective, 
you will see an error message. Refer to “Write to Card” on page 138 for more details.

NOTE: 
You can also save the data to your disk as explained next, and then use the File Utility application to 
transfer the data to the card. See “Writing to an Original Card” on page 184.

Before quitting the application, you should save your file on disk to be able to retrieve it later.

1

Click 

 on the menu bar, then click 

 on the submenu. 

You can also click on the button of the Toolbar shown below: 

If the file already exists on the disk (the file has been saved at least once), the file is saved imme-
diately.

2

If the file name is still 

 or if, for any other reason, the file cannot be found on the disk, the 

application will ask you to enter a file name and select a target folder.

◆

If the card is not brand new, make sure 
that you want to erase the data that is 
already stored on the card and click 

.

◆

Click 

 to exit.

◆

Select the drive, the folder and type the 
file name.

◆

Click 

 to save.

◆

Click 

 to exit.