Справочник Пользователя для Samsung SR8F40

 

operating

Charging

When the product is initially purchased, the battery is fully 
discharged, and you must charge the vacuum cleaning 
robot manually. 

Turn on the Power Switch at the bottom of the product.

1.  After aligning the charge pins of the main unit with 

the charge pin of the charger station, press the main 
unit until you hear a Recharging power sound from 
the charger.

 

- The Charging Lamp turns green.

2.  Check the charge status of the vacuum cleaning robot.

 

- When charging starts, “the amount of remaining battery power” 

and “

” are displayed on the status display panel in this 

sequence.

 

- When charging is complete, the battery level indicator and 

“FULL” will be displayed in the display panel.

flash

flash

 

■

When the battery level display flashes while cleaning, 
the vacuum cleaning robot stops vacuuming and 
automatically charges itself at the charger. 

 

■

If the vacuum cleaning robot starts the current cleaning 
run at a location other than the charging station and fails 
to locate the charging station while cleaning, it will stop 
near the location where it started cleaning.

 

■

When the battery level flashes and “Lo” is displayed while 
cleaning, vacuum cleaning robot cannot be operated by 
the remote control or the buttons on the main unit. In 
this case, directly carry the vacuum cleaning robot to the 
charger to charge the battery. (This is when the battery is 
completely discharged.)

<Charge display>

Charge 
complete

Charging required 

charging

power lamp 

Charging lamp 

power lamp 

Charging lamp 

Charging

fully charged