Справочник Пользователя для Samsung RS727CQRBSLA

Скачать
Страница из 60
12_
 
setting up
4.  Additional flushing may be required in some 
households.
5.  Open the refrigerator door and make sure there 
are no water leaks coming from the water filter.
A newly installed water fi lter cartridge may 
cause water to briefl y spurt from the water 
dispenser. This is due to air getting into the 
line. It should pose no problem to operation.
Check the amount of water supplied 
to the ice tray.
1.  Lift up the icemaker cover and gently pull it out.
2.  When you press the Test button for 3 seconds, 
the ice cube container is filled with water from 
the water supply tap. Check to make sure the 
amount of water is correct (see the illustration 
below). If the water level is too low, the ice cubes 
will be small. This is a water pressure problem 
from within the main water pipes, not the 
refrigerator.
-  It will take a few minutes for the water to 
reach the correct level after you push the 
Test button.
-  Do not press the test button continuously when 
the tray is filled with ice or water. Water may 
overflow or ice jamming may occur.
-  When the bucket is not installed, the ice maker 
does not work.
-  When Ice Off blinks on the display panel, reinsert 
the bucket and/or make sure it’s installed 
properly. 
BEFORE USING ICEMAKER
Remove
-  Hold the handle as shown in 
Figure1.
-  Slightly pull up the bottom part.
-  Take out the ice bucket slowly.
Install
-  Assemble the icemaker in the 
reverse order of disassembly.
-  Push the bucket in firmly until you 
hear a clicking sound.
-  If the bucket does not fit into its 
place, turn the gear handle on its 
back by 90 degrees and reinstall 
it again as shown in Figure 2.
Before calling service
-  Any sounds you hear when 
the ice maker dumps ice into 
the bucket are part of normal 
operation.
-  If you don’t dispense ice for a 
long period of time, the ice may 
form clumps in the ice bucket. If ice clumps form, 
remove the remaining ice and empty the bucket.
-  When ice does not come out, check for ice stuck 
in the chute and remove it.
-  When Ice Off blinks on the display panel, 
reinsert the bucket and/or make sure it’s 
installed properly.
-  When the door is open, the Ice and water 
dispenser do not work.
-  If you close the door hard, it may cause water 
spilling over the ice maker.
-  To prevent dropping the ice bucket, use both 
hands when removing it.
-  To prevent injury, be sure to clean up any ice or 
water that may have dropped on the floor.
-  Do not let the children hang on the ice dispenser 
or on the bucket. They may get hurt.
-  Be sure not to put your hand or any object into 
the ice chute. It may cause personal injury or 
damage mechanical parts.
Removing residual matter inside the 
water supply line after installing fi lter.
1.  Turn ON the main water supply.
2.  Press the Water button and push the Dispenser 
Lever.
3.  Flush 1 gallons of water through the filter before 
use. (Flush approximately 6 minutes.) This will 
clean the water supply system and remove air 
from the lines.
Figure 1
Figure 1
Figure 2
Figure 2
Figure 3
Figure 3
Ice Chute
Ice Chute
Ice
Ice
Water
Water
Ice maker
Ice maker
1
1
Test button
Test button
Check the 
Check the 
water level
water level
2
2
CAUTION
CAUTION