Справочник Пользователя для Samsung Indukční varná deska s Flex Zónou NZ84J9770EK Série NZ9900J
English 11
Ins
talling the hob
Installing the hob
WARNING
Be sure the new appliance is installed and grounded only by qualified personnel.
Please observe this instruction. The warranty will not cover any damage that may occur as a
result of improper installation.
Technical data is provided at the end of this manual.
Please observe this instruction. The warranty will not cover any damage that may occur as a
result of improper installation.
Technical data is provided at the end of this manual.
Safety instructions for the installer
•
A device must be provided in the
electrical installation that allows the
appliance to be disconnected from the
mains at all poles with a contact opening
width of at least 3 mm. Suitable isolation
devices include line protecting cut -
outs, fuses (screw type fuses are to be
removed from the holder), earth leakage
trips and contactors.
electrical installation that allows the
appliance to be disconnected from the
mains at all poles with a contact opening
width of at least 3 mm. Suitable isolation
devices include line protecting cut -
outs, fuses (screw type fuses are to be
removed from the holder), earth leakage
trips and contactors.
•
With respect to fire protection, this
appliance corresponds to EN 60335 -
2 - 6. This type of appliance may be
installed with a high cupboard or wall on
one side.
appliance corresponds to EN 60335 -
2 - 6. This type of appliance may be
installed with a high cupboard or wall on
one side.
•
The installation must guarantee shock
protection.
protection.
•
The kitchen unit in which the appliance
is fitted must satisfy the stability
requirements of DIN 68930.
is fitted must satisfy the stability
requirements of DIN 68930.
•
For protection against moisture, all cut
surfaces are to be sealed with a suitable
sealant.
surfaces are to be sealed with a suitable
sealant.
•
On tiled work surfaces, the joints in
the area where the hob sits must be
completely filled with grout.
the area where the hob sits must be
completely filled with grout.
•
On natural, artificial stone, or ceramic
tops, the snap action springs must be
bonded in place with a suitable artificial
resin or mixed adhesive.
tops, the snap action springs must be
bonded in place with a suitable artificial
resin or mixed adhesive.
•
Ensure that the seal is correctly seated
against the work surface without any
gaps. Additional silicon sealant must not
be applied; this would make removal
more difficult when servicing.
against the work surface without any
gaps. Additional silicon sealant must not
be applied; this would make removal
more difficult when servicing.
•
The hob must be pressed out from below
when removed.
when removed.
•
A board can be installed underneath the
hob.
hob.
•
The ventilation gap between the
worktop and front of the unit
underneath it must not be covered.
worktop and front of the unit
underneath it must not be covered.
NZ84J9770EK_EO_DG68-00631A-01_EN.indd 11
2015-02-05 6:11:45