Справочник Пользователя для Acer altos r510 mk2

69

8

Disconnect the data cable from the rear of the DVD/CD-RW or CD-
ROM drive.

9

Remove the two screws at the rear of the DVD/CD-RW or CD-ROM 
drive to disconnect the interposer board. 

10 Store the screw and interposer board for future use. Suggestion: 

tape the screw to the drive carrier.

11 Slide the empty drive carrier into the chassis until it clicks into 

place.

12 Install the chassis cover. For instructions, see 

“Installing the Chassis 

Cover.”

 

13 (Optional) Install the front bezel. For instructions, see 

“Removing 

and Installing the Front Bezel.”

 

14 Plug all peripheral devices and the AC power cable back into the 

server.

Installing DVD/CD-RW or CD-ROM Drive into 
Slimline Bay (No Backplane Installed)

NOTE: The carrier for the slimline DVD/CD-RW drive / CD-ROM 
drive was pre-installed in the slimline drive bay of your Altos R510 
Server Chassis. The interposer board and floppy drive power 
adapter cable used in these instructions was sent to you with your 
fixed drive kit.

1

Observe the safety and ESD precautions at the beginning of this 
book. See 

“Safety Information.”

2

Power down the server and unplug all peripheral devices and the 
AC power cable.

3

Remove the chassis cover. For instructions, see 

“Removing the 

Chassis Cover.”

4

Remove the front bezel if it is installed. For instructions, see 

“Removing and Installing the Front Bezel.”

 

5

Push in on the blue lever at the rear of the DVD/CD-RW or CD-ROM  
drive carrier and push the carrier out through the front of the 
chassis.