Справочник Пользователя для Acer altos r510 mk2
4 Configuring the system
70
6
Align the two holes at left edge of DVD/CD-RW or CD-ROM drive
with the cutouts in drive carrier. See letter “A” in the figure
below.
with the cutouts in drive carrier. See letter “A” in the figure
below.
7
Lower the right side of the DVD/CD-RW or CD-ROM drive into the
carrier until it clicks into place. See letter “B” in the figure below.
carrier until it clicks into place. See letter “B” in the figure below.
8
Use the two screws indicated in the figure to attach the interpose
board to the DVD/CD-RW or CD-ROM drive. See letters “C” and
“D” in the figure.
board to the DVD/CD-RW or CD-ROM drive. See letters “C” and
“D” in the figure.
9
Insert the DVD/CD-RW or CD-ROM drive carrier into the chassis.
See letter “A” in the figure below.
See letter “A” in the figure below.
10 If it is not already connected, connect the 2x3 end of the DVD/CD-
RW or CD-ROM drive power cable that was included with your
fixed drive kit to the 2x3 power connector on the SATA power
adapter cable. See letters “B” and “C” in the figure below.
fixed drive kit to the 2x3 power connector on the SATA power
adapter cable. See letters “B” and “C” in the figure below.
11 Connect the drive power cable to the power connector on the rear
of the DVD/CD-RW or CD-ROM drive. See letter “D” in the figure.
12 Connect the DVD/CD-RW or CD-ROM drive data cable that was
included with your kit between the interposer board and the IDE
connector on the server board. See letters “E” and “F” in the
figure below. See your server board documentation for assistance
in locating the connector location on the server board.
connector on the server board. See letters “E” and “F” in the
figure below. See your server board documentation for assistance
in locating the connector location on the server board.
13 Route the DVD/CD-RW or CD-ROM drive data cable over the top of
air baffle, as shown in the diagram below.