Справочник Пользователя для ASUS rx3041h

Figure 9.13 displays the screen with entries to: 

 Add a new Self Access rule to: 

•  Allow TCP port 80 traffic (i.e. HTTP traffic) from the LAN and deny the HTTP traffic from the WAN 

port (i.e. from the external network) to the RX3041H. 

To modify a Self Access rule, follow the instructions below: 

1.  Open the Self Access Rule configuration page by clicking on the Firewall 

ΠAdvanced Î Self 

Access menu. 

2.  Click on the 

 icon of the Self Access rule to be modified in the Self Access rule table or select 

the Self Access rule from the Self Access rule drop-down list. 

3.  You may then disable or enable the traffic from LAN or WAN or both. Note that port number 

cannot be changed if TCP or UCP protocol is selected. To modify the port number, you must first 
delete the existing Self Access rule and add a new rule instead. 

4.  Click on the 

 button to save the changes. The new settings for this Self Access rule will 

then be displayed in the Self Access rule table located at the bottom half of the Self Access Rule 
configuration page. 

To delete a Self Access rule, click on the   icon of the rule to be deleted or follow the instruction below: 

1.  Open the Self Access Rule configuration page by clicking on the Firewall 

ΠAdvanced Î Self 

Access menu. 

2.  Click on the 

 icon of the Self Access rule to be deleted in the Self Access rule table or select 

the Self Access rule from the Self Access rule drop-down list. 

3.  Click on the 

 button to delete the rule. Note that the rule deleted will be removed from the 

Self Access rule table located at the bottom half of the same configuration page. 

To see existing Self Access Rules, just open the Self Access Rule configuration page by clicking on the 
Firewall 

ΠAdvanced Î Self Access menu. 

Services are a combination of Protocol and Port number. It is used in inbound and outbound ACL rule 
configuration. 

Table 9.4 describes the available configuration parameters for firewall service list. 

Enter the name of the Service to be added. Note that only alphanumeric 
characters are allowed in a name. 

Enter the type of protocol the service uses. 

Enter the port number that is set for this service.