Справочник Пользователя для ati all-in-wonder x800
Quick Installation 13
CHAPTER 2
Installing Hardware
This chapter will guide you through the physical installation of your ALL-
IN-WONDER® X800 Series card.
IN-WONDER® X800 Series card.
Quick Installation
Experienced users and system administrators can follow these brief
instructions for installing the ALL-IN-WONDER® X800 Series card in the
shortest possible time.
instructions for installing the ALL-IN-WONDER® X800 Series card in the
shortest possible time.
To perform a quick installation
1
Uninstall the drivers and software for your old graphics card if you
have not already done so.
have not already done so.
Note: If you are using a motherboard containing an on-board
graphics solution and do not intend to use it as part of a multiple
monitor display, disable it.
graphics solution and do not intend to use it as part of a multiple
monitor display, disable it.
2
Shut down and disconnect your computer system.
3
Remove any previously installed card.
4
Install your new ALL-IN-WONDER® X800 Series card. Be sure to
plug in the auxiliary power connector.
plug in the auxiliary power connector.
5
Reassemble and connect your computer system.
6
Install the ALL-IN-WONDER® X800 Series drivers and
configuration software from the ATI Installation CD-ROM by doing
one of the following:
configuration software from the ATI Installation CD-ROM by doing
one of the following:
• Run through the automatic
ATISETUP
utility; or
•
Start > Run > X:\ATISETUP.EXE
(where
X
is the drive letter of
your CD-ROM drive).