Справочник Пользователя для Archos dvr station gen 5
DVR Station Gen 5
6
User ManUal - version 3
Select the “
Test channel select
” button. Make sure that your tuner is on. Your
ARCHOS device will then attempt to switch your tuner to the selected channel. After
a few seconds, your ARCHOS will ask you if the device responded correctly:
a few seconds, your ARCHOS will ask you if the device responded correctly:
If this worked, select “
Yes
”.
If this did not work, select “
No, try next option
”. Your device will try again to switch
your tuner to the selected channel, using a different option*. Repeat this operation
until it works.
until it works.
*Here is a description of the different parameters automatically set by the ARCHOS:
“Key Delay”:
delay between the emission of each digit of a channel (“
Short
”, “
Normal
”, “
Long
”).
“Key: Enter”:
Set to “
On
” if normally, you have to press an “
OK
” button on your turner’s remote control
after you enter the channel number. Example: If you normally press 1, 3, “
OK
” to access channel 13, then
this parameter is set to “
On
”.
“Key: -/--”:
Set to “
On
” if normally, you need to press a special key on your tuner’s remote control before
entering a channel with several digit numbers (that is to say a channel greater than 9). This key is often
represented with this symbol: “
represented with this symbol: “
-/--
”.
“Switches on with”:
see below.
“Time until video”:
see below.
If the ARCHOS did not manage to switch your tuner to the selected channel, you can try using a different
ON/OFF code (see:
ON/OFF code (see:
1
st
Test: turning your tuner off
) and do the 2
nd
test again.
After you selected “
Yes” at the end of the 2
nd
step, the following screen appears. You
will have to set these two parameters:
“
Switches on with
”: this depends on what key you normally press, on your
tuner’s remote control, to turn it on. If you normally press the “
Power
” key,
select “
Power
”. If you can press any channel key, then select “
Any channel
”. If
you can press any key, select “
Any key
”.
“
Time until video
”: select the amount of time it normally takes between the
moment you turn on your tuner, and the moment the image appears on your
TV (“
TV (“
0...10 seconds
”, “
10...30 seconds
”, “
>30 seconds
”).
When you have finished, select “
Done
”, and a confirmation message will appear.
Select “
OK
”.
2.
-
-
-
-
-
3.
-
-
4.