Инструкции По Обслуживанию для HP digital sender 9200c
Control panel message
Description
Recommended action
and at the motor are fully seated (see figure
7-3).
7-3).
A defective registration sensor (see figure
7-4) can also create an ADF PAPER JAM
message. Verify that the movement of this
sensor flag is not hindered. Use the
Diagnostics Sensor test to test this sensor.
See
7-4) can also create an ADF PAPER JAM
message. Verify that the movement of this
sensor flag is not hindered. Use the
Diagnostics Sensor test to test this sensor.
See
. Run the diagnostic
program from the control panel and
manually move the flag to see if the status
changes. If the status fails to change, check
the sensor wiring. Clean or replace the
sensor if necessary.
manually move the flag to see if the status
changes. If the status fails to change, check
the sensor wiring. Clean or replace the
sensor if necessary.
ADF PICK ERROR
The ADF experienced an error while
picking media.
picking media.
Make sure that your original contains no
more than 50 pages. Note if anything that is
unusual about the source media might be
causing the jam (see
more than 50 pages. Note if anything that is
unusual about the source media might be
causing the jam (see
Check the status of the pickup rollers and
clean or replace them if necessary. See
clean or replace them if necessary. See
. Verify that the
pickup roller assembly and separation pad
are correctly installed.
are correctly installed.
Check to see whether the ADF read motor
(see figure 7-5) is rotating and attempting to
pull paper through the paper path. Use the
ADF read motor diagnostic test (see
(see figure 7-5) is rotating and attempting to
pull paper through the paper path. Use the
ADF read motor diagnostic test (see
). If the ADF read motor is not
rotating, verify that the connectors at
CN103, on the scanner controller board
(see figure 7-3) and at the motor are fully
seated.
CN103, on the scanner controller board
(see figure 7-3) and at the motor are fully
seated.
ADF SKEW ERROR
Media has become skewed in the ADF.
Make sure that the paper guides are
aligned on the sides of the originals, and
that all of the originals are the same size.
Remove the remaining media from the ADF
and close the ADF cover. Follow the
instructions in the onscreen dialog box.
aligned on the sides of the originals, and
that all of the originals are the same size.
Remove the remaining media from the ADF
and close the ADF cover. Follow the
instructions in the onscreen dialog box.
Authentication information is incorrect.
Please re-enter information.
Please re-enter information.
A user name or password is incorrect.
Type the information again.
Verify that the settings on the
Authentication tab of the HP MFP DSS
Configuration Utility are correct for the
network.
Authentication tab of the HP MFP DSS
Configuration Utility are correct for the
network.
AUTHENTICATION REQUIRED
Authentication has been enabled for this
feature or destination. A user name and
password are required.
feature or destination. A user name and
password are required.
Type the user name and password, or
contact the network administrator.
contact the network administrator.
Canceling send job
The device is canceling a send job. The
message continues while the job is stopped
and any remaining data is discarded.
message continues while the job is stopped
and any remaining data is discarded.
Wait for the cancellation process to
complete.
complete.
CHECK CABLES CHECK SCANNER
LOCK To continue turn off then on
LOCK To continue turn off then on
The scanner might be locked or the
interface cable might be seated incorrectly.
interface cable might be seated incorrectly.
Make sure that the scanner is unlocked and
the interface cable is seated correctly.
the interface cable is seated correctly.
Table 7-1
Control-panel messages (continued)
154
7 Troubleshooting