Инструкции По Обслуживанию для HP digital sender 9200c
Control panel message
Description
Recommended action
. Run the diagnostic program from the
control panel and manually block the
sensor to see if the status changes. If the
status fails to change, check the sensor
wiring. Clean or replace the sensor if
necessary.
sensor to see if the status changes. If the
status fails to change, check the sensor
wiring. Clean or replace the sensor if
necessary.
ADF Empty
No document is in the ADF.
You must have a document in the ADF or
on the glass before you can begin a digital-
send operation.
on the glass before you can begin a digital-
send operation.
The ADF Empty sensor flag is shown in
figure 7-4. When media is inserted into the
ADF input bin, this sensor flag moves and
blocks a photo sensor. Verify that nothing is
hindering the movement of this sensor flag.
figure 7-4. When media is inserted into the
ADF input bin, this sensor flag moves and
blocks a photo sensor. Verify that nothing is
hindering the movement of this sensor flag.
Use the Diagnostics Sensor test to test this
sensor. See
sensor. See
. Run the
diagnostic program from the control panel
and manually move the flag to simulate
media in the ADF. If the status fails to
change, check the sensor wiring. Clean or
replace the sensor if necessary.
and manually move the flag to simulate
media in the ADF. If the status fails to
change, check the sensor wiring. Clean or
replace the sensor if necessary.
ADF Output Bin Full
Too many sheets are in the ADF output bin.
The ADF output bin can hold a maximum of
50 sheets.
The ADF output bin can hold a maximum of
50 sheets.
Under normal circumstances, clearing the
output bin clears this message. If emptying
the ADF output bin does not clear the
message, verify the following items:
output bin clears this message. If emptying
the ADF output bin does not clear the
message, verify the following items:
■
Verify that the movement of the ADF
Bin Full sensor flag (see figure 7-5) is
not being blocked or hindered.
Bin Full sensor flag (see figure 7-5) is
not being blocked or hindered.
■
Verify that the connector for the ADF
Bin Full sensor is fully seated.
Bin Full sensor is fully seated.
Use the Diagnostics Sensor test to test this
sensor. See
sensor. See
. Run the
diagnostic program from the control panel
and manually move the flag to simulate a
full ADF bin. If the status fails to change,
verify the sensor wiring. Clean or replace
the sensor if necessary.
and manually move the flag to simulate a
full ADF bin. If the status fails to change,
verify the sensor wiring. Clean or replace
the sensor if necessary.
ADF Paper Jam
Media is jammed in the ADF.
If the message persists, verify that the clear
mylar sheet, the ADF pickup rollers, and
the separation pad are correctly installed. If
components are worn or excessively dirty,
clean or replace them. Also see
mylar sheet, the ADF pickup rollers, and
the separation pad are correctly installed. If
components are worn or excessively dirty,
clean or replace them. Also see
.
Check to see whether the ADF read motor
is rotating or attempting to pull paper
through the paper path (see figure 7-5).
Use the ADF read motor diagnostic test
(see
is rotating or attempting to pull paper
through the paper path (see figure 7-5).
Use the ADF read motor diagnostic test
(see
). If the ADF read motor
is not rotating, verify that the connectors at
CN103, on the scanner controller board,
CN103, on the scanner controller board,
Table 7-1
Control-panel messages (continued)
Understanding control-panel messages
153