Справочник Пользователя для Panasonic cq-rd324n

20

Fire Wall of Car

Hex. Nut (Option)

Rear Support Strap (Option)

wMounting Bolt

qMounting Collar

Tapping Screw (Option)

3 mmø

Rubber Cushion 
(Option)

wMounting Bolt

qMounting Collar

Rear Support Bracket
(Provided on the car)

q

w

e

r

t

y

Mounting Collar

Mounting Bolt (5 mmø)

Power and Speaker Connector

Removable Face Plate Case

Dismounting Plate

Remote Control Unit

Car Audio

(ATT)

(ATT)

VOL

MODE

MUTE

TRACK

TUNE

1

1

1

1

1

1

u

Lithium Battery (CR 2025)

1

Caution: Do not disconnect the battery terminals of a car
with trip or navigational computer since all user settings
stored in memory will be lost.  Instead take extra care with
installing the unit to prevent shorts.

¡Before installation, check the radio operation with antenna and

speakers.

¡Disconnect the cable from the negative (–) battery terminal

(see caution below).

¡Unit should be installed in a horizontal position with the front

end up at a convenient angle, but not more than 30°.

Installation Opening
The unit can be installed in
any dashboard having an
opening as shown at right.
The dashboard should be
4.5 mm - 6 mm thick in order to be able to support the unit.

Installation Precautions
This product should be installed by a professional installer, if pos-
sible.
In case of difficulty, please consult your nearest authorized
Panasonic Service Center.
1. This system is to be used only in a 12-volt, DC battery system

(car) with negative ground.

2. Follow the electrical connections carefully (

a

Page 18).

Failure to do so may result in damage to the unit.

3. Connect the power lead (red) after all other connections are

made.

4. Be sure to connect the battery lead (yellow) to the positive ter-

minal (+) of the battery or fuse block (BAT) terminal.

5. Insulate all exposed wires to prevent short circuiting.
6. Secure all loose wires after installing the unit.
7. Please carefully read the operating and installation instructions

of the respective equipment before connecting it to this unit.

182 mm

53 mm

30° or less

You may not be able to install this unit in some makes of Japanese
cars.  In such a case, consult your dealer.

To mount this unit on a Japanese car, first cut the 9 slits in back of
the trim plate with side-cut pliers, remove the trim plate, then mount
this unit.

Slit